Dnepro-Bugsky Sea Port

Dnepro-Begsky Sea Port Scheme

ADDRESS

Dnepro-Bugsky Merchant Sea Port LLC NAE
471, Oktyabrskiy Ave., Nikolaev, 54051, Ukraine
Contacts and Phones of Dnepro-Bugsky Port
Reception +380-512-692043
Port Director +380-512-692018
Port Fleet Manager +380-512-692720
Operator on Duty +380-512-692313

INTRODUCTION

Dnepro-Bugsky Sea Port was established as a structural subdivision of the alumina enterprise in Nikolaev. It was put into operation on October 7, 1978, and is designed mainly for handling of imported bauxites. From its very beginning as well as now, it is the only specialized terminal in Ukraine for handling bauxites. After privatization of alumina plant State Enterprise Dnepro-Bugsky Merchant Sea Port (SE DBMSP) provided control of state property not subjected to privatization and navigational safety. Recently the enterprise was included into Nikolaev Merchant Sea Port.

PORT REGULATIONS AND NAVIGATIONAL INFORMATION

General Information

It is a mouth port on the left bank of Bugsky Liman (estuary) in the vicinity to the Russkaya foreland, 10 miles southward from Nikolaev Sea Port, 32 miles from the Black Sea.

The port is navigable year-round. For information about weather conditions refer to the section Nikolaev Merchant Sea Port.

The port’s waters are protected by a dam. The berths are equipped with fender protection. Port waters include the water area between the berthing line and the protective dam. It is connected to the Bugsko-Dneprovskiy Limanskiy Channel (BDLC) via the approach channel, which is 3.14 km in length and 100 m in width. The passage draft is 10.3 m. The depth of the port’s waters is 11.5 m, and near the berths the maximum possible depth is 11.5 m. The total area of the port’s waters is 98 ha.

Entering Port

48 hours prior to the arrival shipmasters of seagoing cargo vessels shall inform the Harbour Master of Nikolaev sea port, setting forth ETA at the port. No later than 48 hours prior to approaching the port, the Port Operator and Agent should be advised of ETA, the ship’s name, overall length, width, draft; its type and quantity of cargo.

Navigational Conditions

The port regularly accommodates Panamax type ships of 215–230 m in length, with their tonnage of up to 60,000 t.

Passage of ships in the BDLC to the port approach channel is possible only during daytime when visibility exceeds 2 miles. Ships can enter and leave the port 24 hours a day, but large-tonnage vessel traffic in the port’s approach channel is not advised when visibility is less than 2 miles.

Ship traffic within port waters is regulated by Port State Control Inspection over VHF radio.

Inside port waters the speed of largetonnage seagoing vessels in load should not exceed 3 knots and, when in ballast, 6 knots. Smalltonnage ships can move through the approach channel at speeds of up to 9 knots.

Ships leaving the port shall give way to ships proceeding along bend No. 9 of BDLC, and to ships in the maneuverable zone or approaching such zones from bend No. 8 and No. 10 of BDLC. Ships overtaking in the port’s approach channel is forbidden.

Pilotage

Pilotage is compulsory for ships bound for Dnepro-Bugsky Port.

Besides a liner pilot, each ship shall pick up a port pilot either at buoy No. 73 on bend No. 8 of BDLC or at buoy No. 93 on bend No. 10.

Exception is only made for ships commanded by shipmasters tested in Port State Control Inspection, who received permission to sail in the port’s waters. The liner pilot must be ordered 8 hours prior to ship’s departure, followed up with further verification of exact time 2 hours prior to departure, the order is addressed to the Harbour Master in written form.

In stormy weather and heavy ice navigation conditions the place for pilot embarkation/disembarkation can be chosen by shipmaster’s agreement with the pilot and the Harbour Master.

Tug Assistance

Pilotage through the port approach channel of seagoing ships of 187 m in length or more must be performed with tug assistance; the required number of tugs is fixed by the Captain on Duty of SPCI of SE NMSP. In the port mooring operations are also to be carried out with the help of port tugs.

Requests for port tugs are submitted to the Operator 2 hours prior to the commencement of mooring operations. During ice period it is given to Port State Control Inspection of SE NMSP.

Mooring operations are forbidden for ships in load when wind speed is 15 m/s or more. When ships are in ballast, mooring operations are impossible under wind speed of 12 m/s or more.

Setting up a tug convoy for two small-tonnage, non-self propelled ships may be carried out only southward of BDLC bend No. 9 and northward of the parallel 46°45'. When organizing a convoy, it is prohibited to block up the BDLC or port approach channel.

Within port waters only one ship (barge) may be towed, and tug capacity should ensure a running speed of no less than 4 knots, provided that the steering is safe.

From the moment when ice navigation announced all maneuvers and berthing operations of cargo vessels in the port must be carried out with a pilot on board.

Anchorage

In the outer roads (bellmouth), temporary anchorage No. 1 at point: Latitude 46°44'37''N Longitude 31°54'21''E, is suitable for one largetonnage sea ship up to 215 m in draft 9.8 m.

In the inner roads, anchorage No. 2 at point Latitude 46°46'13''N, Longitude 31°56'17''E, is suitable for one largetonnage sea ship of up to 215 m in length and 10.3 m in draft. At this anchorage shortterm moorage is also permitted for largetonnage sea ships of more than 215 m in length under compulsory tug support and when wind force does not exceed 4, in order to handle and carry out mooring operations with other ships in the port.

Policy on Staying in Port

For ships with length exceeding 215 m, anchorage in the outer or inner roads, pilotage through port’s approach channel and ship’s berthing are all carried out in compliance with Working Rules Applied to OverSized Units (OSU) and under control of the Harbour Master or his Deputy.

While pending berth, ships of river – sea and river types are anchored southward of the site of bend No. 9 or northward of parallel 46°45'. In stormy weather the laying-up berth for small-tonnage ships and floating structures is determined by Port State Control Inspection.

Mooring and shifting of vessels at the ports berths are carried out under the supervision of DBMSP LLC NAE stevedores. Inspectors of SPCI NMSP perform surveillance of mooring operations.

SPECIALIZATION

The port specialization is to handle imported bauxite for Nikolaev and Zaporozhye alumina plants. Its capacity is 5М t of bauxites and 500,000 t of other cargoes. In 2009, DBMSP LLC NAE handled 4,189,500 t of cargo.

Bauxites are handled on berths Nos. 3, 4, 5. The port transfers bauxite ore and other cargo from large tonnage vessels in the roadstead port point No. 1 of SE DBMSP.

The port has organized the export transshipment of acetic acid, alumina, molasses and residual fuel oil.

PORT FACILITIES

The port’s area is 25 ha. The port has 2 railway tracks; the approach ways to the berths for motor transport. There is one cargo area in the port. The berthing line totals 810 m. There are 5 berths in the port.

Berths of Dnepro-Bugsky Port
Specializations Berths (m) Lenght (m) Depth (m)
General and dry-bulk cargo 1 160,00 5,00
General and dry-bulk cargo, molasses 2 100,00 5,00 - 11,50
Bauxites, molasses 3 160,00 11,50
Bauxites 4 180,00 11,50
Bauxites 5 210,00 11,50

SPECIALIZED TERMINALS

Molasses Handling Terminal

It is supplied with all types of equipment for the round year work including that for warming up of molasses in winter. Storage facilities to accumulate molasses have the total capacity of 20,000 t. The terminal is owned by the company Ukrpishchesbytsyryo Ltd. Molasses are carried to a berth by a special pipeline. Loading is carried out into tankers (berth No 3).

Residual Fuel Oil Handling Terminal

It is intended to export residual fuel oil. The terminal is located on berth No. 5. Its capacity is 1M t a year, 20,000 t a day. There are 6 reservoirs for accumulation of residual fuel oil, which are owned by LLC Nikolaev Alumina Plant. It provides simultaneous storage of 35,000 t. The terminal enables rail tanks to be handled.

Storage Facilities

The port comprises a yard of 15,800 sq. m for storage of up to 150,000 t of bauxites, and an open areafor general cargo storage.

Leave a comment